You are here: Home / Systems / Acrydur® / Acrydur® Industry

Acrydur® Industry

3-component acrylic flooring system

Acrydur® Industry 4-6 mm is ideal for areas, which are subject to very high mechanical or chemical wear with high hygienic demands, such as heavy industry, industrial kitchens, bakeries, slaughter houses, food industry, refrigerator areas, and other areas, where an anti-slip surface and easily cleanable floor is required.

Case Study


  • Aestetically pleasing, silkmat surface
  • Nonslip finish if required
  • Seamless and hygienic finish
  • Very good chemical resistance
  • Easy to clean and sterialise
  • Weatherproof & UV resistent
  • Fast installation
  • Curing down to -30°C
  • Low maintenance cost.

Acrydur® Industry is a smooth multicoloured floor with a silkmatt finish.

Life Expectancy
10 - 20 years.


System datasheet

For all types of medium to heavy load industrial floors, in combination with high demands to hygiene and cleanability. Acrydur® Industry floorings are flexible with a high wearability, impact and chemical resistance. Acrydur® Industry is easy to clean and maintain in a hygienic condition. The very fast curing of Acrydur® floorings means, that eventual production stop is minimized while installing the floor.

Application conditions:
Temperature -30ºC to 30ºC, best 15°C to 25ºC, max. moisture content in the concrete subfloor 5% by weight.

Temperature Resistance:
Acrydur® Industry is resistant to temperature cycles up to 80°C. Extended periods at these temperatures and above will make material susceptible to chemical attack and abrasion wear.


See "colour quartz" range in separate card.

Acrydur® Industry
3-component acrylic flooring system

Resistant to chemicalsSmooth-or- Nonslip     Chock       resistant
Fast curingwatertightColour
    Extremely      hard-wearing  Withstands   heavy-loadsNeutral oder and VOC free

Ulfcar Production Aps
Tværvejen 15
DK-5580 Nørre Aaby

EN 13813 SR-B1,5-AR1-IR4
Synthetic resin screed for internal uses

Fire behavior: Dfl
Release of corrosive substances: SR
Water permeability: NPD
Wear resistance: AR1
Bond strength: B1,5
Impact resistance: IR4
Impact sound insulation: NPD
Sound absorption: NPD
Heat insulation: NPD

Technical data

Fully cured @ 20°C24 hours
Applied thickness4 - 6 mm
Water PermeabilityNil – Karsten test (impermeable)
Hardness SHORE D 80
Compressive strength85 MPa
Reaction to fire Dfl-s1
Bond strength >1.5 MPa
Temperature resistance Up to 80°C at 4 mm
Thermal expansion coefficient <40 ppm
Abrasion resistance50 mg / 1000 cycles (Taber Abrader)
Thermal conductivity< 0,8 W/m·K
Slip resistanceR9 – R13
Food ContactNo contamination

Contact us

Please contact us if you have any questions - we are happy to help.

International Headoffice

 Industrivej 26, DK 5592 Ejby

 +45 70 21 38 88