Acrydur® Top floor
3- component acrylic based flooring system
Acrydur® Topfloor 2-4 mm with a smooth structure is ideal for areas, which are subject to heavy mechanical and chemical wear, with high demands for being free of dust, such as work rooms, storage rooms, laboratories, etc. Acrydur® Topfloor is also suitable for renovation of older Acrydur® floorings.
Benefits:
Aestetically pleasing, silkmat surface
Nonslip finish if required
Seamless and hygienic finish
Very good chemical resistance
Easy to clean and sterialise
UV resistent
Fast installation
Curing down to -30°C
Low maintenance cost.
Appearance:
Acrydur® Topfloor is a smooth floor with a silkmatt finish.
Life Expectancy:
10 - 15 years.
Application:
Acrydur® Topfloor floorings are flexible with excellent wearability, impact and chemical resistance. Acrydur® Topfloor is easy to clean and maintain in a hygienic condition. Typical areas of use are workshops, warehouses, exhibition areas, laboratories, canteens, bathroom facilities, offices and corridors. Acrydur® Topfloor is used also to refresh or renovate old acrylic floors. The very fast curing of Acrydur® floorings means, that an eventual production stop is minimized while installing the floor.
Application conditions:
Temperature -30ºC to 30ºC., best 15 to 25ºC., max. moisture content in the concrete subfloor 5% by weight.
Temperature Resistance:
Acrydur® Topfloor is resistant to temperature cycles up to 80ºC. Extended periods at these temperatures and above will make material susceptible to chemical attack and abrasion wear.
Colours:
Acrydur® Topfloor is available in 4 versions:
- Pigmented, for selection see Colour
- Design look, see Colour Design
- Mottled, see Colour Décor
- Logo, individual company logo design.
Acrydur® Top floor
3- component acrylic based flooring system
![]() | ![]() | ![]() |
Resistant to chemical | Smooth-or- Nonslip | Chock resistant |
![]() | ![]() | ![]() |
Fast curing | Watertight | Colour |
![]() | ![]() | ![]() |
Extremely hard-wearing | Withstands heavy-loads | Neutral oder and VOC free |
Ulfcar Production Aps |
EN 13813 SR-B1,5-AR1-IR4 Fire behavior: Dfl |
Technical data
Properties | Value |
Fully cured @ 20°C | 24 hours |
Applied thickness | 2 - 4 mm |
Water Permeability | Nil – Karsten test (impermeable) |
Hardness | SHORE D 80 |
Compressive strength | 40 MPa |
Reaction to fire | Dfl-s1 |
Bond strength | >1.5 MPa |
Temperature resistance | Up to 80°C at 4 mm |
Thermal expansion coefficient | <40 ppm |
Abrasion resistance | 50 mg / 1000 cycles (Taber Abrader) |
Thermal conductivity | < 0,6 W/m·K |
Slip resistance | R9 – R13 |
Food Contact | No contamination |