You are here: Home / Systems / Epofloor® / Epofloor® Aqua


Epofloor® Aqua

A three pack, solvent free waterbased epoxy flooring material


Epofloor® Aqua 1-4 mm is diffusion open and therefore it can be applied on new-poured concrete floors disregarding the content of moisture in the concrete. Epofloor® Aqua can also be used in areas, where you want to secure pressure equalization from steam outlet, for instance in basements or on magnesite bounded floors.

Case Study


Benefits:

  • Waterbased High impact resistance
  • Seamless and hygienic finish
  • Very good chemical resistance
  • Easy to clean and sterilise
  • Low maintenance cost
  • Attractive appearance
  • High abrasion resistance
  • Solvent free; low odour

Appearance:
Epofloor® Aqua is a smooth floor with a mat finish.

Life Expectancy
3 - 5 years.

 

System datasheet


Application:
Epofloor® Aqua floorings offers excellent wearability, impact and chemical resistance. Epofloor® Aqua is easy to clean and maintain in a hygienic condition. Typical areas of use are basements and wet subfloorings where pressure equalisation from the influence of vapour, for example in cellars and magnesite-bonded floors, must be ensured.

Application conditions:
Temperature 5ºC to 30ºC., best 15 to 20ºC.

Temperature Resistance:
Epofloor® Aqua is resistant to temperature cycles up to 70°C. Extended periods at these temperatures and above will make material susceptible to chemical attack and abrasion wear.


Colours:

Colours Available in a range of standard colours, see the "Colour Quartz" and "Colour" range.




Epofloor® Aqua
A three pack, solvent free waterbased epoxy flooring material


Resistant to chemicalsSmooth-or-Nonslip     Chock       resistant
   Withstands     heavy-loads     Heat       resistanceNeutral oder and VOC free 
ColourFast curingSoundproof
Office chairComfordFire retardant
  
Hygienic  

Ulfcar Production Aps
Tværvejen 15
DK-5580 Nørre Aaby

EN 13813 SR-B1,5-AR1-IR4
Synthetic resin screed for internal uses

Fire behavior: Bfl-s1
Release of corrosive substances: SR
Water permeability: NPD
Wear resistance: AR1
Bond strength: B1,5
Impact resistance: IR4
Impact sound insulation: NPD
Sound absorption: NPD
Heat insulation: NPD


Technical data

PropertiesValue 
Fully cured @ 20°C7 days
Applied thickness0,5 - 1 mm
Water PermeabilityDiffusion open
Hardness SHORE D 80
Compressive strength55 MPa
Reaction to fire Bfl-s1
Bond strength >1.5 MPa
Temperature resistance Up to 70°C at 4 mm
Thermal expansion coefficient <38 ppm
Abrasion resistance50 mg / 1000 cycles (Taber Abrader)
Thermal conductivity< 0,6 W/m·K
Slip resistanceR9 – R13
Food ContactNo contamination

Contact us

Please contact us if you have any questions - we are happy to help.

International Headoffice

 Tværvejen 15, DK-5580 Nr. Åby

 +45 70 21 38 88

 info@ulfcar.com