Epofloor® Industry
A three pack, solvent free epoxy resin based flooring material
Epofloor® Industry 4 - 6 mm is ideal for areas, with high hygienic demands. It is recommended for industrial environments, which are subject to heavy mechanical and chemical wear. The floor is easy to maintain, and is used for industrial production, chemical industry, slaughter houses and other food industries, breweries, etc.
Benefits:
- Non slip finish if required
- High impact resistance
- Seamless and hygienic finish
- Very good chemical resistance
- Easy to clean and sterilise
- Low maintenance cost
- Attractive appearance
- High abrasion resistance
- Solvent free; low odour.
Appearance:
Epofloor Industry is a multicoloured floor which can be produced with a non slip finish as required.
Life Expectancy
10 - 20 years.
Application:
To provide a medium to heavy duty, easy to clean, chemical resistant flooring. The non slip finish can be adjusted to clients need. Typical uses are process, manufacturing, packaging and warehousing areas subjected to heavy wear and pallet truck traffic.
Temperature Resistance:
Epofloor Industry is resistant to temperature cycles up to 70°C. Extended periods at these temperatures and above will make material susceptible to chemical attack and abrasion wear.
Colours:
Colours Available in a range of standard mixes, see the "Colour" range.
Epofloor® Industry
A three pack, solvent free epoxy resin based flooring material
 |  |  |
| Resistant to chemicals | Smooth-or- Nonslip | Chock- resistant |
 |  |  |
| Extremely hard-wearing | Withstands heavy-loads | Neutral oder and VOC free |
 |  |  |
| Watertight | Colour | Fast curing |
 |  |  |
| Hygienic | Office chair | Fire retardant |
|
Ulfcar Production Aps |
EN 13813 SR-B1,5-AR1-IR4 Fire behavior: Dfl |
Technical data
| Properties | Value |
| Fully cured @ 20°C | 7 days |
| Applied thickness | 4 - 6 mm |
| Water Permeability | Nil – Karsten test (impermeable) |
| Hardness | SHORE D 80 |
| Compressive strength | 40 MPa |
| Reaction to fire | Bfl-s1 |
| Bond strength | >1.5 MPa |
| Temperature resistance | Up to 70°C at 4 mm |
| Thermal expansion coefficient | <38 ppm |
| Abrasion resistance | 50 mg / 1000 cycles (Taber Abrader) |
| Thermal conductivity | < 0,6 W/m·K |
| Slip resistance | R9 – R13 |
| Food Contact | No contamination |
