Epofloor® Topfloor
A two pack, solvent free epoxy resin based flooring material
Epofloor® Topfloor 2-4 mm is being used for dry industrial areas, which are subject to normal wear. The floor has a high wear resistance, chock-proof resistance and chemical resistance. At the same time the floor is easy to maintain, and it can be used for storehouses, laboratories, schools, hospitals and other light industries.
Benefits:
- Non slip finish if required
- High impact resistance
- Seamless and hygienic finish
- Very good chemical resistance
- Easy to clean and sterilise
- Low maintenance cost
- Attractive appearance.
- High abrasion resistance
- Solvent free; low odour
- Fast installation.
Appearance:
Epofloor® Topfloor is a smooth floor with a glossy finish.
Life Expectancy
10 - 15 years.
Application:
Epofloor® Topfloor floorings offers excellent wearability, impact and chemical resistance. Epofloor® Topfloor is easy to clean and maintain in a hygienic condition. Typical areas of use are workshops, warehouses, exhibition areas, laboratories, canteens, bathroom facilities, offices and corridors.
Application conditions:
Temperature 10ºC to 30ºC, best 15 to 20ºC, max. moisture content in the concrete subfloor 5% by weight.
Temperature Resistance:
Epofloor® Topfloor is resistant to temperature cycles up to 70°C. Extended periods at these temperatures and above will make material susceptible to chemical attack and abrasion wear.
Colours:
Available in a range of standard mixes, see the "Colour" range.
Epofloor® Topfloor
A two pack, solvent free epoxy resin based flooring material
 |  |  |
| Resistant to chemicals | Smooth-or- Nonslip | Chock resistant |
 |  |  |
| Extremely hard-wearing | Withstands heavy-loads | Neutral oder and VOC free |
 |  |  |
| Watertight | Colour | Fast curing |
 |  |  |
| Hygienic | Office chair | Fire retardant |
|
Ulfcar Production Aps |
EN 13813 SR-B1,5-AR1-IR4 Fire behavior: Bfl-s1 |
Technical data
| Properties | Value |
| Fully cured @ 20°C | 7 days |
| Applied thickness | 2- 4 mm |
| Water Permeability | Nil – Karsten test (impermeable) |
| Hardness | SHORE D 80 |
| Compressive strength | 40 MPa |
| Reaction to fire | Bfl-s1 |
| Bond strength | >1.5 MPa |
| Temperature resistance | Up to 70°C at 4 mm |
| Thermal expansion coefficient | <38 ppm |
| Abrasion resistance | 50 mg / 1000 cycles (Taber Abrader) |
| Thermal conductivity | < 0,4 W/m·K |
| Slip resistance | R9 – R13 |
| Food Contact | No contamination |
