ULFCAR® Base HD
A three component acryllic reinforced cementisious flooring mortar
Ulfcar® Base HD shows exellent properties in the food industry and the mechanical industry where very high mechanical resistance is demanded. Also an economic solution for the renovation of existing concrete floors.
Applicable on wet concrete
Resist 100°C. water temperatures
High abrasion resistance
High impact resistance
Seamless and hygienic finish
Easy to clean and sterilise
Low maintenance cost
Anti slip finish
Low odour during installation.
To provide a heavy duty floor finish with exceptional temperature and medium chemical resistance. Typical uses are wet and dry process areas with hot liquid spillage, hot water cleaning, heavy traffic, impact and medium chemical exposure.
Ulfcar® Base HD is resistant to temperature cycles up to 120oC dry heat and 100oC. wet heat. Extended periods at these temperatures and above will make material susceptible to chemical attack and abrasion wear.
Temperature 5°C to 30°C, best 15 to 20°C.
Ulfcar® Base HD is a coloured smooth or antiskid floor.
15 - 20 years
See standard shades available in "Colour" range.
Ulfcar Production Aps
EN 13813 SR-B1,5-AR1-IR4
Fire behavior: Bfl
|Fully cured @ 20°C||7 days|
|Applied thickness||6 - 12 mm|
|Water Permeability||Nil – Karsten test (impermeable)|
|Hardness||SHORE D 90|
|Compressive strength||55 MPa|
|Reaction to fire||Bfl - s1|
|Bond strength||>1.5 MPa|
|Temperature resistance||up to 130°C at 9 mm|
|Thermal expansion coefficient||<25 ppm|
|Abrasion resistance||50 mg / 1000 cycles (Taber Abrader)|
|Thermal conductivity||< 1.5 W/m·K|
|Slip resistance||R9 – R13|
|Food Contact||No contamination|