ULFCAR® Base MS
Magnesite-based self-levelling floor filler
Ulfcar® Base MS is a perfect solution in dry industries such as car-, electronic-, paper-, tobacco-, glass production areas. Ulfcar® Base MS offers a very high mechanical and chemical resistance.
High impact resistance
Seamless and hygienic finish
Good chemical resistance
Easy to clean and sterilise
Low maintenance cost
High abrasion resistance
Solvent free; low odour
Ulfcar® Base MS floorings offers excellent wearability, impact and chemical resistance. Ulfcar® Base MS is easy to clean and maintain in a hygienic condition. Typical areas of use are in the dry industries such as car-, electronic-, paper-, tobacco-, glass production areas.
Temperature 10°C to 30°C, best 15 to 20°C, max. moisture content in the concrete subfloor 5% by weight.
Ulfcar® Base MS is resistant to temperature cycles up to 120°C. Extended periods at these temperatures is not recommended.
Ulfcar® Base MS is a smooth floor with a mat finish.
15 - 25 years.
See standard shades available in "Colour" range.
Ulfcar Production Aps
EN 13813 SR-B1,5-AR1-IR4
Fire behavior: Bfl
|Fully cured @ 20°C||7 days|
|Applied thickness||6 - 12 mm|
|Water Permeability||Nil – Karsten test (impermeable)|
|Hardness||SHORE D 90|
|Compressive strength||55 MPa|
|Reaction to fire||Bfl - s1|
|Bond strength||>1.5 MPa|
|Temperature resistance||up to 130°C at 9 mm|
|Thermal expansion coefficient||<25 ppm|
|Abrasion resistance||50 mg / 1000 cycles (Taber Abrader)|
|Thermal conductivity||< 1.5 W/m·K|
|Slip resistance||R9 – R13|
|Food Contact||No contamination|