ULFCAR® Base TM
Cement-based trowelling mortar floor filler
Ulfcar® Base TM is ideal for slope building of existing concrete floors as an underlay for Ulfcar® synthetic coverings.
Benefits:
Hydraulic curing - beginning setting after 1/2 hour
Accessible after 2 hours
Seamless finish
Ready for application of resin coatings next day (at 5 mm / 18-20°C)
Low maintenance cost
Low installation cost
Fast installation
Applicable in any wanted layer thickness in one operation.
Application:
Ulfcar® Base TM can be applied and filled on dry and humid areas, when they are solid and free of dust, dirt, oil, fat, wax and other stripping compounds.
About 5,5 litre of fresh cold water and 25 kg Ulfcar® Base TM, must be mixed into a lump-free mortar.
Processing time at 18-20°C: About 30 minutes. Accessible after about 2 hours. Ready for application after 1 day.
Too fast drying of the new applied layer must be avoided.
Application conditions:
Temperature 5°C to 30°C, best 15 to 20°C.
Temperature Resistance:
As concrete .
Appearance:
Ulfcar® Base TM appears as a rough handapplied mortar.
Colours:
As concrete.
Links
Ulfcar Production Aps |
EN 13813 SR-B1,5-AR1-IR4 Fire behavior: Bfl
|
Technical data
Properties | Value |
Fully cured @ 20°C | 7 days |
Applied thickness | 6 - 12 mm |
Water Permeability | Nil – Karsten test (impermeable) |
Hardness | SHORE D 90 |
Compressive strength | 55 MPa |
Reaction to fire | Bfl - s1 |
Bond strength | >1.5 MPa |
Temperature resistance | up to 130°C at 9 mm |
Thermal expansion coefficient | <25 ppm |
Abrasion resistance | 50 mg / 1000 cycles (Taber Abrader) |
Thermal conductivity | < 1.5 W/m·K |
Slip resistance | R9 – R13 |
Food Contact | No contamination |